LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2011 >> 2 Touring, 1.5 Z, Standard >> Repair and Diagnosis >> Restraints >> Restraints Control Systems >> Seat Belt System >> Buckle Switch Inspection >> Driver Side

Driver Side

  1. Switch the ignition to off.
  2. Disconnect the negative battery cable.
  3. Remove the front seat. (See FRONT SEAT REMOVAL/INSTALLATION .)
  4. Remove the front buckle. (See FRONT BUCKLE REMOVAL/INSTALLATION .)
  5. Inspect for continuity between the buckle switch terminals using a tester.
    • If not as indicated in the figure, replace the front buckle.
    Fig 1: Seat Belt Terminal Continuity
    G06941658Courtesy of MAZDA MOTORS CORP.
    Fig 2: Checking Continuity Between Buckle Switch Terminals
    G06941659Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals