Front Power Window Motor
- Fully lower the front door glass.
- Disconnect the negative battery cable.
- Remove the inner garnish (See
INNER GARNISH REMOVAL/INSTALLATION
.)
- Remove the front door trim (See
FRONT DOOR TRIM REMOVAL/INSTALLATION
.)
CAUTION:
- If the bolts are removed without supporting the front door glass, the front door glass may fall off and be damaged. Remove the bolts while inserting your hand into the front door speaker installation hole to support the front door glass.
Courtesy of MAZDA MOTORS CORP.
- Disconnect the front power window motor connector, remove the bolt, then remove the front power window motor from the front power window regulator drum in the direction of the arrow shown in illustration.
- Install in the reverse order of removal.
NOTE:
- When installing the front power window motor to the front power window regulator drum, the drum housing hooks may detach from the door module panel. If this happens, remove the front door speaker, insert your hand in the speaker installation hole, connect the drum housing hooks, and while supporting the drum housing, install the front power window motor to the drum.
Courtesy of MAZDA MOTORS CORP.