LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2011 >> 2 Touring, 1.5 Z, Standard >> Repair and Diagnosis >> Body & Frame >> Door Locks >> Security System And Locks System >> Immobilizer System-Related Parts Programming [Keyless Entry System] >> No. 3 Additional Key Programming Procedure Changing

No. 3 Additional Key Programming Procedure Changing

NOTE:
  • This procedure is performed for disabling the No. 1 Additional Key Programming Procedure (Using Two Valid Keys).
  • The setting is "Customer spare key programming enable" when the vehicle is new or the keyless control module is replaced with a new one.

Procedure 

NO. 3 ADDITIONAL KEY PROGRAMMING PROCEDURE CHANGING DIAGNOSTIC PROCEDURE

Step Procedure Action after procedure
1 CHANGE CUSTOMER SPARE KEY PROGRAMMING PROCEDURE 
  1. Connect the M-MDS to the DLC-2.

    (See M-MDS CONNECTING PROCEDURE .)

  2. Switch the ignition ON using a key (the key can be either the valid key or an unprogrammed key).
    NOTE:
    • If an unprogrammed key is used, the security light starts flashing and DTC 15 is displayed after approx. 1 min.  However, this does not indicate an improper procedure. Continue to perform the procedure as indicated.
  3. After the vehicle is identified, select "Body", then "Security", then "PATS function" from the initial screen of the IDS.
  4. Select either of the following from the M-MDS menu to change the additional key programming procedure.
    • When "Customer Spare Key Programming Enable" is selected: The additional key programming procedure using valid keys is enabled.
    • When "Customer Spare Key Programming Disable" is selected: The additional key programming procedure using valid keys is disabled.
  5. Perform the security access according to the directions on the M-MDS screen.
  6. After verifying that the PATS function menu is displayed again on the M-MDS screen, select "Finish (this menu)".
  7. Switch the ignition to off.
 Procedure is completed
scientia non olet · About LEMON Manuals