No. 5 Programming Procedure Due to Instrument Cluster Replacement

NOTE:

Since two or more keys need to be programmed to start the engine, program two or more keys after the replacement.

Conditions

Have two or more keys to be programmed after the replacement.

Procedure

Fig 1: Identifying Valid Keys

G06942083

Courtesy of MAZDA MOTORS CORP.

NO. 5 PROGRAMMING PROCEDURE DUE TO INSTRUMENT CLUSTER REPLACEMENT DIAGNOSTIC PROCEDURE

Step	Procedure	Action after procedure
1	REPLACE INSTRUMENT CLUSTER Refer to INSTRUMENT CLUSTER REMOVAL/INSTALLATION to perform instrument cluster replacement and configuration. (See INSTRUMENT CLUSTER CONFIGURATION .)	Go to the next step.
2	PERFORM PARAMETER RESET Connect the M-MDS to the DLC-2. (See M-MDS CONNECTING PROCEDURE .) Switch the ignition ON using a key (The key can be either the valid key). NOTE: Although the security light remains illuminated and DTC 15 is displayed after approx. 1 min, continue to perform the procedure as indicated. After the vehicle is identified, select "Body", then "Security", then "PATS function" from the initial screen of the IDS. Then, select an item from the screen menu. item Parameter Reset Perform the security access according to the directions on the M-MDS screen. Select replaced parts "IC" according to the directions on the M-MDS screen. CAUTION: At this time, do not Select other parts from the M-MDS menu. Verify that the PATS function menu is displayed again on the M-MDS screen.	Go to the next step.
3	CLEAR IGNITION KEY ID NUMBERS Select "Ignition Key Code Erase and Program" from the M-MDS screen menu. Clear the ignition key ID number according to the directions on the M-MDS.	Go to the next step.
4	PERFORM IGNITION KEY ID NUMBER PROGRAMMING Program two keys according to the directions on the M-MDS. After verifying that the PATS function menu is displayed again on the M-MDS screen, select "Finish (this menu)". Switch the ignition to off. Switch the ignition to ON. Verify that the security light illuminates for approx. 3 s, and then turns off. Switch the ignition to off. Disconnect the M-MDS from the DLC-2.	Go to the next step.
5	VERIFY PROGRAMMING IS PERFORMED CORRECTLY Verify that the engine can be started with all the keys. Can the engine be started?	Yes	Procedure is completed
5		No	Perform the corresponding DTC inspection to repair the malfunctioning part.