LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2011 >> 2 Sport, 1.5 Z, Standard >> Repair and Diagnosis >> Engine Performance >> System >> On-Board Diagnostic [Engine Control System MZR 1.5] >> DTC P0602:00 >> Notes

DTC P0602:00: Notes

DTC P0602:00 (MZR 1.5) DETECTION CONDITION AND POSSIBLE CAUSES

DTC P0602:00 PCM programming error
DETECTION CONDITION 
  • No configuration data in the PCM.
    NOTE:
    • If the "PCM CONFIGURATION" is successful, the PCM stores the DTC P0602:00 and illuminates the MIL (the system is normal). Clear the DTC P0602:00 using the M-MDS after the "PCM CONFIGURATION".
    • The MIL turns off after three drive cycles with no failure (the DTCs remain in PCM).

    Diagnostic support note 

  • This is a continuous monitor (CCM).
  • The MIL illuminates if the PCM detects the above malfunction condition during the first drive cycle.
  • FREEZE FRAME DATA (Mode 2)/Snapshot data is available.
  • The DTC is stored in the PCM memory.
POSSIBLE CAUSE 
  • Configuration procedure has not been completed
  • PCM malfunction
scientia non olet · About LEMON Manuals