LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2011 >> 2 Sport, 1.5 Y, Standard >> Repair and Diagnosis >> Body & Frame >> Door Locks >> Security System And Locks System >> Front Door Key Cylinder Switch Inspection

Front Door Key Cylinder Switch Inspection

  1. To access the glass installation bolt, position the front door glass so that the distance from the top of the front door glass to the upper part of the front beltline molding is approx. 110 mm {4.33 in}. 
  2. Disconnect the negative battery cable.
  3. Remove the following parts:
    1. Inner garnish (See INNER GARNISH REMOVAL/INSTALLATION .)
    2. Front door trim (See FRONT DOOR TRIM REMOVAL/INSTALLATION .)
    3. Front door speaker (See FRONT DOOR SPEAKER REMOVAL/INSTALLATION .)
    4. Front door glass (See FRONT DOOR GLASS REMOVAL/INSTALLATION .)
    5. Front door module panel (See FRONT DOOR MODULE PANEL REMOVAL/INSTALLATION .)
    6. Front door latch and lock actuator (See FRONT DOOR LATCH AND LOCK ACTUATOR REMOVAL/INSTALLATION .)
    Fig 1: Identifying Distance Between Top Of Front Door Glass To Upper Part Of Front Beltline Molding
    G06941980Courtesy of MAZDA MOTORS CORP.
  4. If the door lock condition is to be inspected, pull the door lock-link switch cable, or press it in.
    NOTE:
    • The door lock-link switch cable locks or unlocks only when the latch lever is locked.
    Fig 2: Identifying Door Lock-Link Switch Cable Lock And Unlock Position
    G06200901Courtesy of MAZDA MOTORS CORP.
  5. Verify that the continuity is as indicated in the table.
    • If not as indicated in the table, replace the front door latch and lock actuator.
    Fig 3: Identifying Front Door Key Cylinder Switch Terminal Continuity Chart
    G06942034Courtesy of MAZDA MOTORS CORP.
    Fig 4: Identifying Front Door Key Cylinder Switch Circuit
    G06942035Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals