Rear Toe Adjustment

Check the toe setting using suitable wheel alignment equipment.
CAUTION:
- The cam nut and cam bolt area must be free of foreign material to make sure of correct clamping.
NOTE:
- Clean the general area of the joint to prevent foreign material from entering the joint. Clean the area using only mild liquids.
NOTE:
- Jounce the vehicle to make sure that the suspension is in its normal, at-rest position.
Loosen the LH and RH rear wheel knuckle bolts.
NOTE:
- Do not remove the rear knuckle cam nut and wheel knuckle bolts. If removed, clean the serrations in the bushing sleeve with a wire brush and install a new wheel knuckle bolt and cam nut.
  
  Fig 1: Locating Wheel Knuckle Bolt And Cam Nut
  Courtesy of MAZDA MOTORS CORP.
Turn the LH and RH adjusting cams simultaneously until the toe is within specification.

Fig 2: Locating Wheel Knuckle Bolt And Cam Nut
Courtesy of MAZDA MOTORS CORP.
Tighten the LH and RH rear wheel knuckle bolts.
- Using a suitable tool, hold the adjustment cam nut stationary while tightening the rear wheel knuckle bolt.
- Tighten to 150 N.m {15.3 kgf.m, 111 ft.lbf}.
  
  Fig 3: Locating Wheel Knuckle Bolt And Cam Nut
  Courtesy of MAZDA MOTORS CORP.
Re-calibrate the steering wheel position sensor. See STEERING SYSTEM .