Fuel Rail Removal/Installation - 2.5L: Installation
- Install the 4 fuel injectors and the 4 retainer clips on the fuel rail.CAUTION:
- Use O-ring seals that are made of fuel-resistant material. Use of ordinary O-rings can cause the fuel system to leak. Do not reuse the O-rings seals.
NOTE:- Install 8 new fuel injector O-ring seals and lubricate them with clean engine oil.
- Install the fuel rail and injectors as an assembly.
- Install the 2 fuel rail stud bolts.
- Tighten to 23 N.m {2.3 kgf.m, 17 ft.lbf}.
- Attach the 2 pin-type wire harness retainers to the fuel rail.
- Position the radio capacitor and install the nut.
- Connect the 4 fuel injector electrical connectors.
- Connect the fuel supply tube quick connect at the fuel rail. See QUICK RELEASE COUPLING - DOUBLE LOCKING .
- Connect the battery ground cable. See BATTERY DISCONNECT .