Variable Swirl System Operation Inspection

1. Connect the M-MDS to the DLC-2.
2. Access the ECT PID.
3. Verify that the ECT PID is below 60°C {140°F}. 
4. Start the engine.
5. Inspect the rod operation under the following conditions:

Rod operation 

If the rod operation is not specified, inspect as follows: 

1. Perform the KOER self test using the M-MDS and verify that DTCs No.P2004:00, P2006:00, P2009:00 or P2010:00 are not displayed. (See KOEO/KOER SELF TEST [L3 WITH TC] .)
   • If DTC No.P2004:00, P2006:00, P2009:00 or P2010:00 are displayed, perform DTC inspection. (See DTC P2004:00 .) (See DTC P2006:00 .) (See DTC P2009:00 .) (See DTC P2010:00 .)

If simulation function of M-MDS is used: 

1. Turn the ignition switch to the ON position (engine off).
2. Turn the variable swirl solenoid valve from off to on using the IMRC PID and verify that the operation sound of the solenoid valve is heard.
   • If the operation sound is not heard, replace the variable swirl solenoid valve. (See VARIABLE SWIRL SOLENOID VALVE INSPECTION .)
   • If the operation sound is not heard, inspect the following:
     • Vacuum hose and vacuum chamber for looseness or damage
     • Shutter valve actuator (See VARIABLE SWIRL SHUTTER VALVE ACTUATOR INSPECTION .)
     • Check valve is stuck open or closed
     • Shutter valve cannot move smoothly

If simulation function of M-MDS is not used: 

1. Inspect variable swirl solenoid valve. (See VARIABLE SWIRL SOLENOID VALVE INSPECTION .)
   • If the variable swirl solenoid valve is not normal, replace the variable swirl solenoid valve.
   • If the variable swirl solenoid valve is normal, inspect the following:
     • Vacuum hose and vacuum chamber for looseness or damage
     • Shutter valve actuator (See VARIABLE SWIRL SHUTTER VALVE ACTUATOR INSPECTION .)
     • Check valve is stuck open or closed
     • Shutter valve cannot move smoothly