| 2 |
PERFORM PARAMETER RESET
- Connect the M-MDS to the DLC-2.
(See
M-MDS CONNECTING PROCEDURE .)
- Turn the ignition switch to the ON position using the valid key or the valid advanced key.
NOTE:
- Although the security light remains illuminated and DTC 23 is displayed after approx. 1 min
, continue to perform the procedure as indicated.
- Verify that the keyless warning light illuminates for approx. 3 s
, and then turns off.
- After vehicle identification, select the following from the M-MDS initial screen.
- Using an IDS (laptop PC):
- Select the "Body"
- Select the "Security"
- Select the "PATS Functions"
- Using a PDS (Pocket PC):
- Select the "All Tests and Calibrations"
- Select the "PATS Functions"
- Select "Parameter Reset" from the M-MDS screen menu.
- Perform the security access according to the directions on the M-MDS screen. (See
SECURITY ACCESS PROCEDURE .)
- Select the replaced parts (PCM) according to the directions on the M-MDS screen.
CAUTION:
- At this time, do not select the other parts from the M-MDS menu.
- After verifying that the PATS function menu is displayed again on the M-MDS screen, select "Finish (this menu)".
- Turn the ignition switch to the LOCK position.
- Turn the ignition switch to the ON position.
- Verify that the security light illuminates for approx. 3 s
, and then turns off.
- Turn the ignition switch to the LOCK position.
|
Go to the next step. |