LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2010 >> 6 s Touring Plus >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (Engine Control System (L5)) >> Neutral Switch Inspection [L5] >> Continuity Inspection

Continuity Inspection

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect the negative battery cable.
  2. Remove the neutral switch. (See NEUTRAL SWITCH REMOVAL/INSTALLATION [G66M-R] .)
  3. Inspect for continuity between the neutral switch terminals using an ohmmeter.
    • If not as specified, replace the neutral switch. (See NEUTRAL SWITCH REMOVAL/INSTALLATION [G66M-R] .)
      Fig 1: Identifying Neutral Switch Components & Connector Terminals
      G06205234Courtesy of MAZDA MOTORS CORP.
      SPECIFICATION

      Measured condition Continuity
      Rod pushed Continuity detected
      Except above No continuity
scientia non olet · About LEMON Manuals