LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2010 >> 3 i SV, 2.0 F >> Repair and Diagnosis >> Engine Performance >> System >> On-Board Diagnostic [Engine Control System LF, L5] >> DTC P0602:00 >> Notes

DTC P0602:00: Notes

DTC P0602:00 (LF, L5) DETECTION CONDITION AND POSSIBLE CAUSE

DTC P0602:00 PCM programming error
DETECTION CONDITION 
  • No configuration data in the PCM.
NOTE:
  • If the "PCM CONFIGURATION" is successful, the PCM stores the DTC P0602:00 and illuminates the MIL (system is normal). Clear the DTC P0602:00 using the M-MDS after the "PCM CONFIGURATION".
  • The MIL goes out after three drive cycles with no failure (The DTCs remain in the PCM).
Diagnostic support note 
  • This is a continuous monitor (CCM).
  • The MIL illuminates if the PCM detects the above malfunction condition in the first drive cycle.
  • FREEZE FRAME DATA (Mode 2)/Snapshot data is available.
  • The DTC is stored in the PCM memory.
POSSIBLE CAUSE 
  • PCM configuration has not been completed
  • PCM malfunction
scientia non olet · About LEMON Manuals