Clutch Pedal Position (CPP) Switch Inspection
- Verify that the CPP switch is installed properly.
- Remove the battery cover. (See BATTERY REMOVAL/INSTALLATION [LF, L5] .)
- Disconnect the negative battery cable.
- Disconnect the CPP switch connector. (See CLUTCH PEDAL REMOVAL/INSTALLATION .)
- Inspect for continuity between the CPP switch terminals using an ohmmeter.
- If not as specified, replace the CPP switch. (See CLUTCH PEDAL REMOVAL/INSTALLATION .)
Specification
CONTINUITY CHART
| Measured condition | Clutch pedal position | Continuity |
|---|---|---|
| Rod pushed | Clutch pedal released | Continuity detected |
| Except above | Clutch pedal depressed | No continuity |