LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2010 >> 3 Mazdaspeed, 2.3 4 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Control System [LF, L5]) >> Camshaft Position (CMP) Sensor Removal/Installation

Camshaft Position (CMP) Sensor Removal/Installation

WARNING: This page is about a different variant/trim than selected.
CAUTION:
  • When replacing the CMP sensor, make sure there is no foreign material on it such as metal shavings. If it is installed with foreign material, the sensor output signal will malfunction resulting from fluctuation in magnetic flux and cause a deterioration in engine control.
  1. Remove the battery cover. (See BATTERY REMOVAL/INSTALLATION [LF, L5] .)
  2. Disconnect the negative battery cable.
  3. Remove the plug hole plate. (See PLUG HOLE PLATE REMOVAL/INSTALLATION .)
  4. Disconnect the CMP sensor connector.
  5. Remove the CMP sensor.
  6. Install in the reverse order of removal.
    Fig 1: CMP Sensor With Torque Specifications
    G06205259Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals