LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2010 >> 3 Mazdaspeed, 2.3 4 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 17 (Manual Transaxle (Service, Removal & Installation G35M-R)) >> Back-Up Light Switch Removal/Installation

Back-Up Light Switch Removal/Installation

WARNING: This page is about a different variant/trim than selected.
  1. Remove the battery cover. (See BATTERY REMOVAL/INSTALLATION [LF, L5] .)
  2. Disconnect the negative battery cable.
  3. Remove the battery component, (ex: battery, battery tray and PCM component) (See BATTERY REMOVAL/INSTALLATION [LF, L5] .)
  4. Remove the aerodynamic under cover No. 2. (See AERODYNAMIC UNDER COVER NO. 2 REMOVAL/INSTALLATION .)
  5. Drain the oil from the transaxle. (See TRANSAXLE OIL REPLACEMENT .)
  6. Disconnect the back-up light switch connector and remove the back-up light switch.
  7. Install the back-up light switch (with a new gasket) to the transaxle case.

    Tightening torque 

    20-29 N.m {2.1-2.9 kgf.m, 15-21 ft.lbf} 

  8. Install the battery component, (ex: battery, battery tray and PCM component) (See BATTERY REMOVAL/INSTALLATION [LF, L5] .)
  9. Install the battery cover. (See BATTERY REMOVAL/INSTALLATION [LF, L5] .)
    Fig 1: Identifying Back-Up Light Switch Connector, Back-Up Light Switch And Gasket
    G06734202Courtesy of MAZDA MOTORS CORP.
  10. Add the specified amount and type of oil. (See TRANSAXLE OIL REPLACEMENT .)
  11. Install the aerodynamic under cover No. 2. (See AERODYNAMIC UNDER COVER NO. 2 REMOVAL/INSTALLATION .)
scientia non olet · About LEMON Manuals