LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2010 >> 3 Mazdaspeed, 2.3 4 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 16 (Starting System [LF, L5]) >> Starter Interlock Switch Inspection

Starter Interlock Switch Inspection

WARNING: This page is about a different variant/trim than selected.
CAUTION:
  • Do not reuse the starter interlock switch if it is removed from the vehicle even once. Replace with a new starter interlock switch when installing.
  1. Disconnect the negative battery cable.
  2. Disconnect the starter interlock switch connector.
  3. Verify that the continuity is as indicated in the table below using a tester.
    Fig 1: Continuity Table
    G06733974Courtesy of MAZDA MOTORS CORP.
    • If the continuity is not as indicated in the table above, replace the starter interlock switch. (See CLUTCH PEDAL REMOVAL/INSTALLATION .)
      Fig 2: Identifying Starter Interlock Switch Connector Terminals
      G06151032Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals