LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2010 >> 3 Mazdaspeed, 2.3 4 >> Repair and Diagnosis >> Engine Mechanical >> Starter >> Starting System [L3 With TC] >> Starter Interlock Switch Inspection

Starter Interlock Switch Inspection

CAUTION:
  • Do not reuse the starter interlock switch if it is removed from the vehicle even once. Replace with a new starter interlock switch when installing.
  1. Remove the battery cover. (See BATTERY REMOVAL/INSTALLATION [L3 WITH TC] .)
  2. Disconnect the negative battery cable.
  3. Disconnect the starter interlock switch connector.
  4. Verify that the continuity is as indicated in the table below using a tester.
    Fig 1: Continuity Table
    G06733974Courtesy of MAZDA MOTORS CORP.
    • If the continuity is not as indicated in the table above, replace the starter interlock switch. (See CLUTCH PEDAL REMOVAL/INSTALLATION .)
      Fig 2: Identifying Starter Interlock Switch Connector Terminals
      G06151032Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals