LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2010 >> 3 Mazdaspeed, 2.3 4 >> Repair and Diagnosis >> Body & Frame >> Windows >> Glass/Windows/Mirrors >> Power Outer Mirror Inspection

Power Outer Mirror Inspection

  1. Disconnect the negative battery cable.
  2. Remove the inner garnish. (See INNER GARNISH REMOVAL/INSTALLATION .)
  3. Disconnect the power outer mirror connector.
  4. Remove the front door trim. (See FRONT DOOR TRIM REMOVAL/INSTALLATION .)
  5. Apply battery positive voltage and connect the ground to the power outer mirror terminals and inspect the power outer mirror operation.
    • If the power outer mirror does not operate as indicated in the table, replace it.
      POWER OUTER MIRROR OPERATION CHART

      Mirror operation direction Terminal
      B+ Ground
      Up G H
      Down H G
      Left I H
      Right H I
      Fig 1: Inspecting Power Outer Mirror Operation
      G06731847Courtesy of MAZDA MOTORS CORP.
  6. Apply battery voltage to power outer mirror connector terminal A, and connect terminal C to ground.
    • If not as indicated in the table in illustration, or if the resistance is not within the specification, replace the power outer mirror.
      Fig 2: Power Outer Mirror Connector Terminals Resistance Chart
      G06731848Courtesy of MAZDA MOTORS CORP.
      Fig 3: Applying Battery Voltage To Power Outer Mirror Connector Terminal A
      G06731849Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals