No. 5 Programming Procedure After Simultaneous Replacement of Immobilizer System-related Parts (PCM, Keyless Control Module, Steering Lock Unit, and Key): Notes
CAUTION:
- The engine cannot be started if any step or procedure is skipped. Perform all procedures in the order of the steps.
NOTE:
- If the keyless control module is replaced, complete the configuration before performing the following menu.
- If the PCM is replaced, complete the configuration before performing the following menu.
- When replacing the keyless control module or the steering lock unit, remove the valid keys and the valid advanced keys from the vehicle (keep them 1 m or more from the vehicle) and switch the ignition ON according to the directions on the M-MDS screen. Select, "There is no programmed ignition key and programmed advanced key" from the M-MDS screen.
CAUTION:
- If the ignition is switched ON by selecting "FORCED IGNITION ON", the engine cannot be started.
- Although the security light or the keyless warning light illuminates or flashes, this does not indicate an improper procedure. Continue to perform the procedure as indicated.
CAUTION:
M-MDS menu
- Parameter Reset
- Ignition Key Code Erase and Program
- Program Additional Advanced Key
- Steering Lock Unit Programming
M-MDS EXECUTION MENU/SEQUENCE
| Replacement part | M-MDS execution menu/sequence | Conditions |
|---|---|---|
| Keyless control module and PCM | (1)→(2)→(3)→(4) |
|
| Keyless control module and steering lock unit | ||
| Keyless control module, PCM, and steering lock unit | ||
| PCM and steering lock unit | (1)→(4) | Have two or more keys to be programmed after the replacement. |