TC6 TGAC Functional Test
- PCM connector connected.
- Transaxle Assembly-B connector connected.
- Isolate the TGAC pin from the Transaxle-B connector.
- Connect a 5 amp fused jumper wire between the following:
Point A Transaxle Assembly-B Connector, Harness Side Point B Transaxle Assembly-B Connector, Harness Side TGAC - Pin 9 TMAC - Pin 4 - Key ON, engine running.
- Does the engine start now?
- Yes:
INSTALL a new transaxle assembly.
REFER to the AUTOMATIC TRANSAXLE - TRIBUTE HYBRID .
- No: GO to TC8 .
- Yes:
INSTALL a new transaxle assembly.