Generator Warning Light

Verify that the battery is fully charged.
Verify that the drive belt deflection/tension is within the specification. (See DRIVE BELT DEFLECTION/TENSION INSPECTION [13B-MSP] .)
With the ignition switch turn to the ON position, verify that the generator warning light illuminates.
- If it does not illuminate, inspect the generator warning light and the wiring harness.
  - If the generator warning light and the wiring harness are normal, inspect the PCM.
Verify that the generator warning light goes out after the engine is started.
- If the generator warning light does not go out, perform the DTC inspection, then perform troubleshooting according to the corresponding diagnostic procedure. (See ON-BOARD DIAGNOSTIC TEST [13B-MSP] .) (See DTC TABLE [13B-MSP] .)