LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2009 >> RX-8 R3, 1.3 2 >> Repair and Diagnosis >> External Pages >> Different car >> Section 545 (Engine Control System) >> Oil Pressure Sensor Removal/Installation [13B-MSP]

Oil Pressure Sensor Removal/Installation [13B-MSP]

WARNING: This page is about a different car, the 2010 Mazda RX-8. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the battery cover. (See BATTERY REMOVAL/INSTALLATION [13B-MSP] .)
  2. Disconnect the negative battery cable.
  3. Remove the extension manifold (upper.) (See INTAKE MANIFOLD REMOVAL/INSTALLATION [13B-MSP] )
  4. Remove the extension manifold (lower.) (See INTAKE MANIFOLD REMOVAL/INSTALLATION [13B-MSP] )
  5. Disconnect the oil pressure sensor connector.
  6. Remove the oil pressure sensor.
  7. Install in the reverse order of removal.
Fig 1: Oil Pressure Sensor With Screws Torque Specification
G05981160Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals