LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2009 >> RX-8 R3, 1.3 2 >> Repair and Diagnosis >> Body & Frame >> Door Locks >> Security System And Locks System >> Immobilizer System-Related Parts Programming [With Advanced Keyless System] >> No. 3 Additional Key Programming Procedure Changing >> Procedure

No. 3 Additional Key Programming Procedure Changing: Procedure

KEY PROGRAMMING PROCEDURE

Step Procedure Action after procedure
1 CHANGE CUSTOMER SPARE KEY PROGRAMMING PROCEDURE 
  1. Connect the M-MDS to the DLC-2. (See M-MDS CONNECTING PROCEDURE .)
  2. Turn the ignition switch to the ON position using a key (The key can be either the valid key or an unprogrammed key.)
    NOTE:
    • If an unprogrammed key is used, the security light starts flashing and DTC 15 is displayed after approx. 1 min  . However, this does not indicate an improper procedure. Continue to perform the procedure as indicated.
  3. After vehicle identification, select the following from the M-MDS initial screen.
    • Using an IDS (laptop PC)
      1. Select the "Body"
      2. Select the "Security"
      3. Select the "PATS function"
    • Using a PDS (Pocket PC):
    1. Select the "All Tests and Calibrations"
    2. Select the "PATS Functions"
  4. Select either of the following from the M-MDS menu to change the additional key programming procedure.
    • When "Customer Spare Key Programming Enable" is selected: The additional key programming procedure using valid keys is enabled.
    • When "Customer Spare Key Programming Disable" is selected: The additional key programming procedure using valid keys is disabled.
  5. Perform the security access according to the directions on the M-MDS screen.
  6. After verifying that the PATS function menu is displayed again on the M-MDS screen, select "Finish (this menu)".
  7. Turn the ignition switch to the LOCK position.
 Procedure is completed
scientia non olet · About LEMON Manuals