LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2009 >> CX-7 Touring, 2.3 3, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 581 (Control System (HVAC)) >> Blower Motor Installation >> Notes

Blower Motor Installation: Notes

WARNING: This page is about a different car, the 2009 Mazda 3. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the SST  to the blower motor. (See BLOWER MOTOR REMOVAL ).
  2. Install the blower motor with the SST (49 B061 015)  installed, to the A/C unit. (See BLOWER MOTOR INSTALLATION NOTE ).
  3. Install the blower motor cover from the driver's side. (See BLOWER MOTOR COVER INSTALLATION NOTE ).
  4. Connect the blower motor connector as shown in the figure.
    Fig 1: Identifying Blower Motor Connector
    G04956354Courtesy of MAZDA MOTORS CORP.
  5. Install the blower motor cooling pipe.
  6. Remove the SST (49 B061 015)  from the blower motor.
  7. Install the airflow mode actuator. (See AIRFLOW MODE ACTUATOR REMOVAL/INSTALLATION ).
  8. Install the air guide.
  9. Connect the resistor connector. (Manual air conditioner)
  10. Install the blower case.
    Fig 2: Identifying Blower Motor Cooling Pipe
    G04956355Courtesy of MAZDA MOTORS CORP.
    CAUTION:
    • Install the blower case while pressing the dashboard insulator, otherwise the blower case could be damaged.
  11. Connect the air intake actuator connector.
  12. Install the following parts:
    1. Auto leveling control module
    2. Car-navigation unit (See CAR-NAVIGATION UNIT REMOVAL/INSTALLATION .)
    3. PJB and PJB bracket (See PASSENGER JUNCTION BOX (PJB) REMOVAL/INSTALLATION .)
    4. Brake pedal (See BRAKE PEDAL REMOVAL/INSTALLATION .)
    5. Accelerator pedal (See ACCELERATOR PEDAL REMOVAL/INSTALLATION [L3 WITH TC] or ACCELERATOR PEDAL REMOVAL/INSTALLATION [LF, L3] .)
    6. Steering shaft (See STEERING WHEEL AND COLUMN REMOVAL/INSTALLATION .)
    7. Instrument cluster (See INSTRUMENT CLUSTER REMOVAL/INSTALLATION .)
    8. Meter hood (See METER HOOD REMOVAL/INSTALLATION .)
    9. Column cover (See COLUMN COVER REMOVAL/INSTALLATION .)
    10. Lower panel (See LOWER PANEL REMOVAL/INSTALLATION .)
    11. Hood release lever (See HOOD LATCH AND RELEASE LEVER REMOVAL/INSTALLATION .)
    12. Glove compartment (See GLOVE COMPARTMENT REMOVAL/INSTALLATION .)
    13. Decoration panel (See DECORATION PANEL REMOVAL/INSTALLATION .)
    14. Front side trim (RH) (See FRONT SIDE TRIM REMOVAL/INSTALLATION .)
    15. Front scuff plate (RH) (See FRONT SCUFF PLATE REMOVAL/INSTALLATION .)
scientia non olet · About LEMON Manuals