LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2009 >> 6 s Touring >> Repair and Diagnosis >> Restraints >> Restraints Control Systems >> Seat Belt System >> Adjuster Anchor Removal/Installation

Adjuster Anchor Removal/Installation

WARNING:
  • The side air bag sensor is attached to the lower part of the B-pillar. When working around the B-pillar, disconnect the negative battery cable or work carefully, avoiding excessive impact to the lower part of the B-pillar.
  1. Remove the following parts:
    1. Front scuff plate. See FRONT SCUFF PLATE REMOVAL/INSTALLATION .
    2. Rear scuff plate. See REAR SCUFF PLATE REMOVAL/INSTALLATION .
    3. B-pillar lower trim. See B-PILLAR LOWER TRIM REMOVAL/INSTALLATION .
    4. Front seat belt upper anchor installation bolt. See FRONT SEAT BELT REMOVAL/INSTALLATION .
    5. B-pillar upper trim. See B-PILLAR UPPER TRIM REMOVAL/INSTALLATION .
  2. Remove bolts.
  3. Remove the adjuster anchor.
  4. Install in the reverse order of removal.
    Fig 1: Adjuster Anchor And Bolts With Torque Specifications
    G06206095Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals