DTC P2108 [L3]: Notes
DTC P2108 (L3) DETECTION CONDITION & POSSIBLE CAUSES
| DTC P2108 |
Throttle actuator control module performance error |
| DETECTION CONDITION |
- PCM detects either following conditions, PCM determines that throttle actuator control system has malfunction.
- TP sensor power supply voltage below 4.4 V
- TP sensor No.1 output voltage below 0.20 V or above 4.85 V
(DTC P0122 or DTC P0123)
- PCM internal circuit for TP sensor No.1 input circuit malfunction.
Diagnostic support note
- This is a continuous monitor (CCM).
- MIL illuminates if the PCM detects the above malfunction condition during the first drive cycle.
- FREEZE FRAME DATA is available.
- The DTC is stored in the PCM memory.
|
| POSSIBLE CAUSE |
- TP sensor No.1 malfunction
- TP sensor No.2 malfunction
- Connector or terminal malfunction
- PCM malfunction
|