LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2009 >> 5 Sport, 2.3 L, Standard >> Repair and Diagnosis >> Restraints >> Restraints Control Systems >> Seat Belt System >> Front Buckle Removal/Installation

Front Buckle Removal/Installation

  1. Turn the ignition switch to the LOCK position.
  2. Remove the battery cover. (See BATTERY REMOVAL/INSTALLATION [L3] .)
  3. Disconnect the negative battery cable.
  4. Remove the front seat. (See FRONT SEAT REMOVAL/INSTALLATION .)
  5. Detach the tab as shown in the figure and remove the connector from the front seat connector.
    Fig 1: View Of Front Seat Connector
    G05545501Courtesy of MAZDA MOTORS CORP.
  6. Remove in the order indicated in the table.
    Fig 2: View Of Front Buckle With Torque Specifications
    G05545502Courtesy of MAZDA MOTORS CORP.
  7. Install in the reverse order of removal.
  8. Verify that the air bag system warning light illuminates for approx. 6 s  and then goes out when the ignition switch is turned to the ON position.
    • If the air bag system warning light does not operate, refer to the on-board diagnostic system (air bag system) and perform inspection of the system.
scientia non olet · About LEMON Manuals