Ignition Switch Inspection

WARNING: This page is about a different car, the 2006 Mazda Tribute. However, it is still accessible from the selected car via links, so may be relevant.

Remove the ignition switch. See REMOVAL AND INSTALLATION .

Inspect for continuity between the ignition switch terminals using an ohmmeter.

Fig 1: Identifying Ignition Switch Connector

Courtesy of MAZDA MOTORS CORP.

INSPECTION CHART

Circuit to test	Connect self-powered test light or ohmmeter to terminals	Move key to these positions	A good switch will indicate
Run/Start power circuit	4 and 1	Off/Lock	Open circuit
		Accessory	Open circuit
		Run	Closed circuit
		Start	Closed circuit
Run/Ace power circuit	4 and 6	Off/Lock	Open circuit
		Accessory	Closed circuit
		Run	Closed circuit
		Start	Open circuit
Start power circuit	4 and 7	Off/Lock	Open circuit
		Accessory	Open circuit
		Run	Open circuit
		Start	Closed circuit

If not as specified, replace the ignition switch.