LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2008 >> Tribute Hybrid Touring, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 765 (Engine Control System) >> Powertrain Control Module (Pcm) Inspection >> Using SST (150 Pin Breakout Box)

Using SST (150 Pin Breakout Box)

WARNING: This page is about a different car, the 2006 Mazda Tribute. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative battery cable.
  2. Disconnect the PCM connector.
  3. Connect the SST (150 Pin Breakout Box) to the PCM as shown.
    Fig 1: Connecting SST Breakout Box to Powertrain Control Module
    G04320304Courtesy of MAZDA MOTORS CORP.
  4. Tighten the connector bolt.

    Tightening torque 7.9 - 10.7 N.m (80 - 110 kgf.m, 69.5 - 95.4 in.lbf) 

  5. Connect the negative battery cable.
  6. Measure the voltage at each terminal.
  7. If any incorrect voltage is detected, check related systems, wiring harnesses and connectors referring to the possible malfunction in the terminal voltage list.
scientia non olet · About LEMON Manuals