LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2008 >> B4000 SE, Standard >> Repair and Diagnosis >> Steering >> Power Steering >> Power Steering System >> Steering Wheel >> Removal and Installation

Removal and Installation

  1. Turn the steering wheel to the straight-ahead position and turn the ignition switch to the OFF position.
  2. Remove the driver air bag module. See DRIVER AIR BAG MODULE , .
  3. Loosen the steering wheel bolt.
    • To install, tighten to 40 N-m {4.1 kgf-m, 30 ft-lbf}.
    Fig 1: Identifying SST (205-116)
    G04930708
    CAUTION:
    • Removing the steering wheel without using a puller can damage the column bearings.
  4. Using SST  205-116, loosen the steering wheel.
  5. Remove and discard the steering wheel bolt.
  6. Remove the steering wheel.
    • Route the wires from the clockspring through the steering wheel.
    NOTE:
    • A new steering wheel bolt must be installed.
  7. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals