LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2008 >> B2300 Standard >> Repair and Diagnosis >> Suspension >> Front Suspension >> Front Suspension System >> Upper Arm >> Installation

Upper Arm: Installation

NOTE: Do not tighten the nuts at this time.
NOTE: Make sure that the set shims are installed in their original positions.
  1. Position the upper arm and loosely install the 2 upper arm flag bolts, set shims and nuts.
  2. Install the upper ball joint and ball joint nut.
    • Tighten to 63 N-m (6.4 kgf-m, 46 ft-lbf).
  3. Position a suitable jack under the front suspension lower arm and raise the suspension until the index marks on the lower arm and the fram are aligned (Curb Height).
    CAUTION:
    • Make sure the upper arm bolts are held in place when tightening nuts. Failure to do so may result in incorrect torque.
  4. Tighten the upper arm nuts to 133 N-m (13.6 kgf-m, 98 ft-lbf).
  5. Install the wheel and tire. See WHEEL AND TIRE
  6. Check and, if necessary, align the front end. See WHEEL ALIGNMENT .
scientia non olet · About LEMON Manuals