LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2008 >> B2300 Automatic >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission [Shift Mechanism] >> Selector Lever Removal / Installation

Selector Lever Removal / Installation

  1. Remove the ignition switch. See IGNITION SWITCH .
  2. Remove the upper steering column shroud and the rubber shift lever cover.
    Fig 1: View Of Upper Steering Column Shroud And Rubber Shift Lever Cover
    G04309522Courtesy of MAZDA MOTORS CORP.
  3. Remove the selector lever.
    1. Disconnect the shift control selector lever harness connector.
    2. Remove and discard the gearshift lever pin.
    3. Remove the gearshift lever.
    Fig 2: View Of Shift Control Selector Lever And Harness Connector
    G04309523Courtesy of MAZDA MOTORS CORP.
    NOTE:
    • The gearshift lever pin must be replaced whenever removed.
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals