LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2008 >> 5 Sport, 2.3 L, Standard >> Repair and Diagnosis >> Restraints >> Restraints Control Systems >> Seat Belt System >> Front Buckle Removal/Installation

Front Buckle Removal/Installation

  1. Turn the ignition switch to the LOCK position.
  2. Remove the battery cover. (See BATTERY REMOVAL/INSTALLATION [L3] .)
  3. Disconnect the negative battery cable.
  4. Remove the front seat. (See FRONT SEAT REMOVAL/INSTALLATION .)
  5. Detach the tab as shown in the figure and remove the connector from the front seat connector.
    Fig 1: Removing Connector From Front Seat Connector
    G05545501Courtesy of MAZDA MOTORS CORP.
  6. Remove in the order indicated in the table.
    Fig 2: Front Buckle With Torque Specifications
    G05545502Courtesy of MAZDA MOTORS CORP.
  7. Install in the reverse order of removal.
  8. Verify that the air bag system warning light illuminates for approx. 6 s  and then goes out when the ignition switch is turned to the ON position.
    • If the air bag system warning light does not operate, refer to the on-board diagnostic system (air bag system) and perform inspection of the system.
scientia non olet · About LEMON Manuals