LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2008 >> 3 Mazdaspeed, 2.3 L >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 7 (Automatic Transaxle [Shift Mechanism]) >> Selector Cable Adjustment

Selector Cable Adjustment

WARNING: This page is about a different variant/trim than selected.
  1. Remove the console. (See CONSOLE REMOVAL/INSTALLATION .)
  2. Shift the selector lever to P position.
  3. Unlock the lock piece of the selector cable (selector lever side) in the order as shown in the figure.
  4. Verify that the manual shaft is in the P position.
    Fig 1: Removing Lock Piece And Safety Lock
    G04956149Courtesy of MAZDA MOTORS CORP.
  5. Lock the lock piece and safety lock of the selector cable (selector lever side) in the order as shown in the figure.
  6. Install the console. (See CONSOLE REMOVAL/INSTALLATION .)
  7. Shift the selector lever from the P position to M range, and make sure that there are no other components in that area to interfere with the lever.
    Fig 2: Installing Lock Piece And Safety Lock
    G04956150Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals