LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2008 >> 3 Mazdaspeed, 2.3 L >> Repair and Diagnosis >> Body & Frame >> Door Locks >> Security System And Locks System >> Transmitter Battery Inspection

Transmitter Battery Inspection

CAUTION:
  • Since the battery voltage does not drop fully if the button is pushed for only 4 s or less, sufficient battery voltage cannot be determined. Always push the button for 5 s.
NOTE:
  • A correct measurement cannot be obtained if the battery temperature is low. Make sure the battery is at 18°C {64°F} or more  for at least 30 min  before reinspecting if a measurement value is under the standard voltage.
  1. Remove the transmitter cover.
  2. Apply the ohmmeter leads to the positions as indicated in the figure.
    Fig 1: Applying Ohmmeter Leads To Specified Positions
    G04956864Courtesy of MAZDA MOTORS CORP.
  3. While pressing the battery as shown in the figure, press the LOCK and UNLOCK buttons on the transmitter at the same time to start measurement of the voltage.
  4. Release the buttons after 5 s. 
  5. Verify that the minimum voltage is the standard voltage or more for 10 s  after starting measurement.
    • If the voltage is under the standard voltage, replace the battery.
      Fig 2: Pressing LOCK And UNLOCK Buttons On Transmitter
      G04956865Courtesy of MAZDA MOTORS CORP.

    Standard voltage 

    2.7 V 

scientia non olet · About LEMON Manuals