Keyless Control Module Removal/Installation

1. When replacing the keyless control module, perform the following procedure:
   • KEYLESS CONTROL MODULE CONFIGURATION (See KEYLESS CONTROL MODULE CONFIGURATION .)
2. Disconnect the negative battery cable.
3. Remove the front side trim. (see FRONT SIDE TRIM REMOVAL/INSTALLATION .)
4. Remove the nut and screw.
5. Remove the connector clip installed to the bracket by shifting the keyless control module downward.
6. Disconnect the keyless control module connector.
   Fig 1: Identifying Keyless Control Module Remove/Install Components

   Courtesy of MAZDA MOTORS CORP.
7. Push the stopper with a small screwdriver and remove the bracket in the direction shown by the arrow.
8. Install in the reverse order of removal.

Fig 2: Removing Bracket

Courtesy of MAZDA MOTORS CORP.