LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2007 >> CX-7 Touring, AWD >> Repair and Diagnosis >> Transmission >> Automatic Trans >> On-Board Diagnostic [Automatic Transaxle) >> DTC P0708 >> Diagnostic procedure

Diagnostic procedure

DTC P0708[AW6A-EL, AW6AX-EL] DIAGNOSTIC PROCEDURE

STEP INSPECTION ACTION
1 VERIFY FREEZE FRAME DATA HAS BEEN RECORDED 
  • Has the FREEZE FRAME DATA been recorded?
 Yes Go to the next step.
No Record the FREEZE FRAME DATA on the repair order, then go to the next step.
2 VERIFY RELATED REPAIR INFORMATION AVAILABILITY 
  • Verify related Service Bulletins and/or on-line repair information availability.
  • Is any related repair information available?
 Yes Perform repair or diagnosis according to the available repair information.
  • If the vehicle is not repaired, go to the next step.
No Replace the TCM, then go to the next step. (See TCM REMOVAL/INSTALLATION ).
3 VERIFY TROUBLESHOOTING OF DTC P0708 COMPLETED 
  • Make sure to reconnect all the disconnected connectors.
  • Clear the DTC from the memory using the M-MDS.
  • Drive the vehicle in each range (P-D).
  • Is same DTC present?
 Yes Replace the TCM, then go to the next step. (See TCM REMOVAL/INSTALLATION ).
No Go to the next step.
4 VERIFY AFTER REPAIR PROCEDURE 
 Yes Go to the applicable DTC inspection. (See DTC TABLE .)
No DTC troubleshooting completed.
scientia non olet · About LEMON Manuals