On-Board System Readiness Tests Access Procedure

Connect the M-MDS to the DLC-2.
After the vehicle is identified, select the following items from the initial screen of the M-MDS.
- When using the IDS (notebook PC)
  1. Select the "Toolbox" tab.
  2. Select "Powertrain".
  3. Select "OBD Test Modes".
  4. Select "Mode 1 Powertrain Data".
- When using the PDS (pocket PC)
  1. Select "OBD II Modes".
  2. Select "Mode 1 Powertrain Data".
Then, select the "***SUP" and "***EVAL" PIDs in the PID selection screen.
Monitor those PIDs and check it system monitor is completed.

Fig 1: Identifying DLC-2 Connector
Courtesy of MAZDA MOTORS CORP.