Passenger's Side
- Measure the voltage at each terminal (other than terminals H and I).
- If the voltage is not as specified in the Terminal Voltage Table, inspect the parts under "Inspection item(s)" and related wiring harnesses.
- Disconnect the negative battery cable.
- Inspect the power window subswitch connector for continuity at terminals H and I.
- If the system does not work properly even though the inspection items or related wiring harnesses do not have any malfunction, replace the power window subswitch.
VOLTAGE REFERENCE
| Terminal | Signal name | Connected to | Measured condition | Voltage (V)/Continuity | Inspection item (s) |
|---|---|---|---|---|---|
| L | Power-cut signal | Power window main switch | Ignition switch at ON and power-cut switch at UNLOCK | B+ |
|
| K | Open output | Power window motor | While door glass is opening | B+ |
|
| While door glass is closing | 1.0 or less | ||||
| J | Pulse 1 | Power window motor | Door glass moving | Alternates between 1.0 and B+ |
|
| I | Power supply | P/W 30 A fuse | Under any condition | B+ |
|
| H | Pulse 2 | Power window motor | Door glass moving | Alternates between 1.0 or less and B+ |
|
| Door glass stopped | 1.0 or less or B+ | ||||
| F | GND | Body ground | Under any condition: Inspect for continuity to ground | Continuity detected |
|
| D | Sensor ground | Power window motor | Under any condition: inspect for continuity to ground | Continuity detected |
|
| C | Close output | Power window motor | While door glass is opening | 1.0 or less |
|
| While door glass is closing | B+ | ||||
| B | Power supply | Power window motor | Ignition switch at ON or during IG-OFF timer | B+ |
|
| A | Communication | Power window main switch | - | - | - |