Specifications Index
CX-7 SPECIFICATIONS INDEX
| System | Specification/Procedure | ||
|---|---|---|---|
| Air Conditioning | |||
| Service | HVAC TECHNICAL DATA | ||
| Torque | See Torque Specifications in appropriate graphics under BASIC SYSTEM - HVAC . | ||
| Axle Nut/Hub Nut | |||
| Front | 174-202 Ft. Lbs. (235-274 N.m) | ||
| Rear | 174-202 Ft. Lbs. (235-274 N.m) | ||
| Battery | BATTERY INSPECTION [L3 WITH TC] | ||
| Brakes | |||
| Bleeding Sequence | AIR BLEEDING | ||
| Disc Brakes | |||
| Service Specifications | BRAKES TECHNICAL DATA | ||
| Torque | See Torque Specifications in text and appropriate graphics under CONVENTIONAL BRAKE SYSTEM . | ||
| Charging | |||
| Generator | GENERATOR INSPECTION[L3 WITH TC] | ||
| Torque | See Torque Specifications in text and appropriate graphics under CHARGING SYSTEM . | ||
| Drive Belts | |||
| Adjustment | DRIVE BELT AUTO TENSIONER INSPECTIONS WITH TC] | ||
| Belt Routing | See appropriate graphic under DRIVE BELT REMOVAL/INSTALLATION[L3 WITH TC] . | ||
| Engine Cooling | |||
| General Service Specifications | TECHNICAL DATA (ENGINE) | ||
| Radiator Cap Pressure | 16-21 psi | ||
| Thermostat R & I | THERMOSTAT REMOVAL/INSTALLATION[L3 WITH TC] | ||
| Water Pump R & I | WATER PUMP REMOVAL/INSTALLATION[L3 WITH TC] | ||
| Engine Mechanical | |||
| 2.3L 4-Cyl. (L3) | |||
| Compression | COMPRESSION INSPECTION[L3 WITH TC] | ||
| Oil Pressure | 43-80 psi (297-551 kPa; 3.03-5.61 kg/cm2 ) at 3,000 RPM. | ||
| Overhaul | TECHNICAL DATA (ENGINE) | ||
| Torque | See Torque Specifications in text and appropriate graphics under MECHANICAL - 2.3L (L3 WITH TC) -- OVERHAUL . | ||
| Fluid Specifications | See FLUIDS under MAINTENANCE tab. From within Manager or Service Writer, click the "30/60/90 Interval" or "Maint." button. | ||
| Flywheel/Flex Plate/Drive Plate Torque | 79.7-85.5 ft.lbf (108-116 N.m) | ||
| Fuel System | |||
| Pressure Specification | 60-71 psi (410-490 kPa; 4.2-4.9 kg/cm2 ) | ||
| Fuel Pressure Test Procedure | FUEL LINE PRESSURE INSPECTION[L3 WITH TC] | ||
| Fuel Filter Location | Fuel filter is attached to fuel pump unit in fuel tank. | ||
| Fuel Filter R & I | FUEL PUMP UNIT REMOVAL/INSTALLATION[L3 WITH TC] | ||
| Ignition | |||
| Firing Order & Cylinder Identification | FIRING ORDER & CYLINDER IDENTIFICATION | ||
| Ignition Wires (Resistance) | The 2.3L engine is equipped with coil-on-plug ignition. | ||
| Ignition Wires (Routing) | The 2.3L engine is equipped with coil-on-plug ignition. | ||
| Spark Plug | |||
| 2.3L 4-Cyl. (NGK L3K9 18 110A or L3Y3 18 110) | |||
| Gap | 0.028-0.031 in. (0.7-0.8 mm) | ||
| Torque | 8.0-10 Ft. Lbs. (10-14 N.m) | ||
| Starting | |||
| Starter | STARTER INSPECTION[L3 WITH TC] | ||
| Torque | See Torque Specifications in appropriate graphics under STARTING SYSTEM . | ||
| Wheel Alignment | |||
| Adjustment Specifications | |||
| Front | FRONT WHEEL ALIGNMENT | ||
| Rear | REAR WHEEL ALIGNMENT | ||
| Torque | See Torque Specifications in text under WHEEL ALIGNMENT . | ||
| Wheel & Tire | |||
| Wheel Lug Nut Torque | 65-86 Ft. Lbs. (88-118 N.m) | ||