LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2007 >> B3000 Base, Standard >> Repair and Diagnosis (Single Page) >> General Information >> OBD-II Drive Cycles >> Drive Cycles >> 2009-11: RX-8 >> Mode 5 (AIR System Repair Verification Drive Mode)

Mode 5 (AIR System Repair Verification Drive Mode)

  1. Verify that all accessory loads (A/C, headlights, blower fan, rear window defroster) are off.
  2. Drive the vehicle as shown inFig 1. The driving condition before driving at constant speed is not specified.
    3. Fig 1: Vehicle Speed Graph - Mode 5
    G05982303Courtesy of MAZDA MOTORS CORP.
  3. Stop the vehicle and access the ON BOARD SYSTEM READINESS to inspect the Drive Mode completion status.
    • If completed, RFC changes from No to Yes.
    • If not completed, turn the ignition switch off, then go back to Step 2.
  4. Access the DIAGNOSTIC MONITORING TEST RESULTS to inspect the monitor results.
    • If detect values are not within specification, repair has not been completed.
  5. Verify that no DTCs are available.
scientia non olet · About LEMON Manuals