LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2007 >> B3000 Base, Standard >> Repair and Diagnosis (Single Page) >> General Information >> OBD-II Drive Cycles >> Drive Cycles >> 2005: MX-5 MIATA >> Mode 1 (PCM Adaptive Memory Production Drive Mode)

Mode 1 (PCM Adaptive Memory Production Drive Mode)

  1. Start the engine and warm it up completely.
  2. Verify the following conditions and correct if necessary:
    • All accessory loads (A/C, headlights, blower fan, rear window defroster) are off.
    • Initial ignition timing and idle speed are within the specification.
    • TEN and GND of DLC are not connected.
  3. Perform no load racing at the engine speed shown in the graph, then idle the engine for more than20 s  after the cooling fan has stopped. If possible, monitor RPM PID for engine speed and FAN2 PID (with A/C), FAN1 PID (without A/C) for cooling fan status during this procedure.
    Fig 1: Identifying PCM Adaptive Memory Production Drive Mode
    G03637551Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals