LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2007 >> B3000 Base, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 546 (Security System And Locks System) >> Door Lock Switch Removal/Installation >> RH

Door Lock Switch Removal/Installation: RH

WARNING: This page is about a different car, the 2005 Mazda RX-8. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative battery cable.
  2. Using a flathead screwdriver wrapped with protective tape, pry up the rear of the switch panel and detach the clip.
  3. Remove the switch panel from the front door trim keeping the tab from catching.
  4. Disconnect the power door lock switch connector and the power window subswitch connector.
    Fig 1: Removing Switch Panel From Front Door Trim
    G03703154Courtesy of MAZDA MOTORS CORP.
  5. Remove the screws, then remove the power door lock switch.
  6. Install in the reverse order of removal.
    Fig 2: Removing Screws Of Power Door Lock Switch
    G03703155Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals