LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2007 >> 6 s, 4D Hatchback, Standard >> Repair and Diagnosis >> Drivelines & Axles >> Differentials & Drive Axles >> On-Board Diagnostic [AWD Control System] >> Electronic AWD Control System On-Board Diagnosis >> Reading DTCs Procedure

Reading DTCs Procedure

  1. Connect the M-MDS to the DLC-2 connector.
  2. After the vehicle is identified, select the following items from the initial screen of the M-MDS.
    • When using the IDS (laptop PC)
      1. Select the "Toolbox" tab.
      2. Select "Self Test".
      3. Select "Modules".
      4. Select "4x4".
    • When using the PDS (Pocket PC)
      1. Select "Module Tests".
      2. Select "4x4".
      3. Select "Self Test".
    Fig 1: Locating DLC-2 Connector
    G04325977Courtesy of MAZDA MOTORS CORP.
  3. Verify the DTC according to the directions on the screen.
    • If any DTCs are displayed, perform troubleshooting according to the corresponding DTC inspection.
  4. After completion of repairs, clear all DTCs stored in the AWD CM. (See 03-02-2 Electronic AWD CONTROL SYSTEM ON-BOARD DIAGNOSIS.)
scientia non olet · About LEMON Manuals