LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2007 >> 6 s, 4D Hatchback, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 740 (Manual Transaxle [Service, Removal & Installation A26M-R)) >> Neutral Switch Removal/Installation [A26M-R]

Neutral Switch Removal/Installation [A26M-R]

WARNING: This page is about a different car, the 2008 Mazda 3. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative battery cable.
  2. Remove the under cover.
  3. Disconnect the neutral switch connector.
  4. Remove the neutral switch.
  5. Install the neutral switch to the transaxle case.

    Tightening torque 

    28.1-52.3 N.m {2.9-5.3 kgf.m, 20.8-38.5 ft.lbf} 

  6. Clamp both the neutral switch and back-up light switch wiring harnesses as shown in the figure.
  7. Install the under cover.
  8. Connect the negative battery cable.
    Fig 1: Identifying Neutral Switch And Back-Up Light Switch Wiring Harnesses
    G04955895Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals