LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2007 >> 6 s, 4D Hatchback, Automatic >> Repair and Diagnosis >> Engine Performance >> System >> Symptom Troubleshooting [Engine Control System AJ) >> Intermittent Concern Troubleshooting >> Vibration Method >> Inspection Method for Switch Connectors or Wires

Inspection Method for Switch Connectors or Wires

  1. Connect the M-MDS to the DLC-2.
  2. Turn ignition switch to ON position (Engine OFF).
    NOTE:
    • If the engine starts and runs, perform the following steps at idle.
  3. Access PIDs for the switch you are inspecting.
  4. Turn switch on manually.
  5. Shake each connector or wire harness a little vertically and horizontally while monitoring the PID.
    • If PID value is unstable, check for poor connection.
      Fig 1: Shaking Connector Or Wire Harness For Poor Connection
      G04324278Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals