Inspection Method for Actuators or Relays
- Connect the M-MDS to the DLC-2.
- Turn ignition switch to ON position (Engine OFF).
NOTE:
- If engine starts and runs, perform the following steps at idle.
- Prepare the output device control function for actuators or relays that you are inspecting.
- Vibrate the actuator or relay with your finger for 3 s
after output device control function is activated.
- If a variable click sound is heard, check for poor connection or poorly mounted actuator/relay, or both.
NOTE:
- Vibrating relays too strongly may result in open relays.
Courtesy of MAZDA MOTORS CORP.