Continuity Inspection

1. Verify that the clutch switch is installed properly.
2. Disconnect the negative battery cable.
3. Remove the clutch switch.
4. Inspect for continuity between the clutch switch terminals using an ohmmeter.
   • If the clutch switch is normal, but PID value is out of specification, perform the "Circuit Open/Short Inspection".
   • If not as specified, replace the clutch switch.

Specification 

Fig 1: Continuity Table

Courtesy of MAZDA MOTORS CORP.

Fig 2: Identifying Clutch Pedal Position (CPP) Switch

Courtesy of MAZDA MOTORS CORP.