LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2007 >> 6 Mazdaspeed >> Repair and Diagnosis >> External Pages >> Different car >> Section 703 (Interior Trim) >> Meter Hood Removal/Installation

Meter Hood Removal/Installation

WARNING: This page is about a different car, the 2008 Mazda 3. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the following parts:
    1. Front scuff plate (Driver's side) (See FRONT SCUFF PLATE REMOVAL/INSTALLATION ).
    2. Front side trim (Driver's side) (See FRONT SIDE TRIM REMOVAL/INSTALLATION ).
    3. Decoration panel (See DECORATION PANEL REMOVAL/INSTALLATION ).
    4. Hood release lever (See HOOD LATCH AND RELEASE LEVER REMOVAL/INSTALLATION .)
    5. Lower panel (See LOWER PANEL REMOVAL/INSTALLATION ).
  2. Detach the fit of the meter hood rubber from the upper column cover.
  3. Pull the meter hood outward and detach the tabs A and locator pins B.
  4. Remove the meter hood.
  5. Install in the reverse order of removal.
    Fig 1: Identifying Meter Hood Tabs And Pins
    G04956929Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals