SAS Control Module Configuration

WARNING: This page is about a different car, the 2008 Mazda 3. However, it is still accessible from the selected car via links, so may be relevant.

Connect the M-MDS to the DLC-2 connector.
After the vehicle is identified, select the following items from the initialization screen of the M-MDS.
- When using the IDS (laptop PC)
  1. Select "Module Programming".
- When using the PDS (Pocket PC)
  1. Select "Programming".
  2. Select "Module Programming".
    
    Fig 1: Identifying DLC-2 Connector
    Courtesy of MAZDA MOTORS CORP.
Then, select items from the screen menu in the following order.
1. Select "Programmable Module Installation".
2. Select "RCM".
Perform the configuration according to the directions on the screen.